Notes:
1 lt is recommended to ride the Kickscooter only on flat hard roads, without obstacles or other pavements unsuitable for ridingincluding but not limited to slippery grounds, loose sand, grave ground and ice surace). ln case of special pavements such asspeed bumps and pits, please keep a medium or low speed (5-10km/h) and slightly bend your needs to better adapt to suchcomplex pavements
2. Typical battery life: lt is tested when the battery is fully charped and the scooter is running at a constant speed (60% of themaximum speed) with a 60kg load at an ambient temperature of 25'C on a level road. The actualbattery life is related to the loadtemperature. speedpavement and other factors
3. All product pictures displayed on the whole website are schematic diagrams of structures and functons instead of productsin kind. They are for reference only, and the actual product will prevail eventually
4. Refer to local traffic regulations for specific road rule. lt is recommended to use the Kickscooter on loop roads (e.g. roads incommunitiesparks and special venues)
5. The above data comes from the laboratory of Ninebot, and may be different in actual riding due to the riding habit, terrain.temperature and other factors

PLEASE NOTE:

DISCLAIMER AROUND SPEED AND RANGE：

THE PRODUCT WAS TESTED FULLY CHARGED, WITH AN AVERAGE LOAD OF 75KG-85KG, AT A NORMAL TEMPERATURE ON A NORMAL PAVED ROAD BETWEEN THE SPEEDS OF 0-25KM/H. THE RESULTS MAY VARY BASED ON DIFFERENCES IN TEMPERATURE, LOAD, WIND SPEED, ROAD CONDITIONS AND OTHER FACTORS.

EACH STATE AND TERRITORY IN AUSTRALIA HAS A DIFFERENT SET OF RULES AND REGULATIONS PERTAINING TO THE USAGE OF E-SCOOTERS, E-BIKES AND E-BOARDS (INCLUDING WHERE E-SCOOTERS, E-BIKES AND E-BOARDS CAN LEGALLY BE USED AND WHETHER E-SCOOTERS, E-BIKES AND E-BOARDS NEED TO BE REGISTERED WITH THE RELEVANT ROAD TRAFFIC AUTHORITY). ANY USER OF THIS PRODUCT MUST ENSURE THAT THAT THEY CHECK AND ABIDE BY THEIR LOCAL BY-LAWS AND USE RESPONSIBLY. RIDE WITH CAUTION AND ALWAYS WEAR A HELMET AND PROTECTIVE GEAR WHEN RIDING YOUR E-SCOOTER, E-BIKE AND E-BOARD. BEFORE RIDING YOUR E-BIKE, E-SCOOTER AND E-BOARD ENSURE THE BOLTS ARE TIGHT AND THE BATTERY IS CHARGED.